Welcome to the tutorial for the HARSLE Hydraulic Guillotine Shear equipped with the DAC-360T controller. This guide will walk you through the basic operations and settings to get you started with your machine.
Part 1 Fill The Oil and Cable Connections
Filling the oil tank with anti-wear hydraulic oil.
Fill the oil from this port.
No less than 2/3 of the Oil Volume Level.
Connect the machine to the power source.
Connect to a 3-phase power source.
Switch on the power source.
Connection of air source for pneumatic rear supporters.
Connect the pedal switch to the machine.
Turn On the Machine Power Switch
Turn on the key switch, the indicator light will be on Release all emergency stop switches
Long press the reset button
Long press the pump-start key Confirmation of indicator lamps.
One single lamp on indicates a wiring phase sequence error.
Press the emergency stop.
Exchange the two wires connection.
Turn the power on again to confirm the indicator light condition.
Both lights are on, indicating the correct wiring connection.
Part 2 Machine Start-up
Turn On the Machine Power Switch
Turn on the key switch, the indicator light will be on
Release all emergency stop switches
Long press the reset button
Long press the pump-start key
Waiting For the System Loading
Part 3 System Operation
Start Programming
Input the sheet thickness of 2mm
Input the sheet length of 150mm
Start-up and running
The system automatically calculates and adjusts the shearing angle.
Part 4 Cutting
Placing the metal sheet.
The sheet will touch the stop fingers.
Step the pedal switch and cut.
Part 5 Measurement & Calibration
Measure the length of the cutting sheet.
It shows 145.5mm. Problem found, there is a 0.5mm error.
Click on the icon
Click to Maintance
Input the actual measured length, which is 145.5mm
Calibration completed Cut again for testing.
Measure again
It is correct now
Part 6 Functions
Show The system automatically alerts and indicates the content of the error.
Part 7 Switch Off
Press the red Stop button
Press the emergency stop buttons
Turn off the power switch
Conclusion
This tutorial covers the essential operations and settings for the HARSLE Hydraulic Guillotine Shear with the DAC-360T controller. By following these steps, you can ensure precise and efficient cutting for your sheet metal projects. For more detailed instructions, refer to the machine's user manual or contact HARSLE customer support.
English
Pусский
